Samsung DW80R9950 Serie Manual De Instalación página 18

Installation
3. Use the provided nut connector to connect the water hose to the dishwasher.
Follow these steps:
01
01 Disconnect the 90° fitting (A) from the hose (B).
02 Remove the seal (C) and the nut (D) from the 90° fitting.
03 From the provided nut connector, separate the seal (E) and the nut (F), and then
assemble them to the 90° fitting as shown in the figure. You must insert the smaller
side of the seal.
4. Then, insert the
the / " fitting is tight. Do not over tighten.
3
4
5. Detach the Velcro strips that secure the drain hose to the back of the dishwasher. Roll-
out the hose. Make sure there are no kinks and that the hose is not bent at any extreme
angles that could constrict the flow of water.
6. Remove the junction box cover located at the bottom front right of the dishwasher
using a screwdriver, and then Install the strain relief (Figure 4-C). Make sure to keep
the junction box cover you removed. It is used in STEP 11, Wiring Connections.
7. If the countertop is made of wood or a material that is not damaged by drilling, attach
the two (2) Installation brackets that were supplied with the dishwasher using the
supplied screws (Figure 4-A). They will be used in STEP 9, Securing the Dishwasher.
If the drain hose needs to go to the
right of the dishwasher, secure the hose
in the hose fixer mounted on the base.
There are three positions the hose fixer
can be installed at. To move the hose
fixer, gently squeeze the fixer, then
turn to the left.
Make sure to secure on the arrow-
marked area.
18 English
DW9900R_DD68-00208A-00_EN.indd 18
02
A
C
B
/ " 90 degree fitting into the inlet valve (See Figure 4-B). Tighten until
3
4
03
E
D F
12/29/2018 1:57:17 PM