Filling With Water - Oster DURA PRESS 6020 Manual De Instrucciones

INSTRUCTIONS FOR USE
You must fill the Water Reservoir with water to use the SHOT OF STEAM® and SPRAY
MIST® features and to get steam out of your Iron.
TIP: Each Iron is tested at the factory to ensure that they function correctly. The test
may leave a small, harmless amount of water within the Water Reservoir.
Before you fill the Water Reservoir, please consider the following:
• While this Iron was designed for use with tap water, very hard water will reduce the
performance of the Iron. If your water is very hard, it is recommended that you use tap
water the first time, then consider using demineralized or distilled water for
subsequent use. You should use tap water once a month, however, to maintain the
Iron's optimal steam performance.
• Do not use water that has passed through a home water softening system. This type
of water contains minerals that will decrease the performance and shorten the life of
your Iron. Use demineralized or distilled water, instead.
IMPORTANT: When not ironing, always set the Steam Lever to O/OFF and the Fabric
Select Dial to Off/Apag.
To fill the Water Reservoir:
1. Lift the Water Fill Hole Cover.
2. Make sure the Iron is unplugged. Set the
Steam Lever to O/OFF and the Fabric
Select Dial to Off/Apag.
3. Fill Water Cup with water. Pour water into
Iron's Water Reservoir. Do not fill Water Reservoir beyond maximum fill level.
WARNING: To prevent the risk of burns, be careful when filling a hot iron with water.
Hot metal parts, hot water and steam can cause injuries.

Filling With Water

5