Fanimation The Benito Manual Del Propietário página 11

How to Assemble the Blades and Light Kit (continued)
4. Connect the 2-pin connector from the socket plate
assembly to 2-pin connector from motor assembly
(Figure 4).
5. Remove one of the three screws in the socket
plate assembly. Slightly loosen the remaining
two screws. Assemle the socket plate
assembly to the adapter plate assembly using
the two key slots. Replace the third screw and
securely tighten all three screws (Figure 5).
6. Insert light bulbs into sockets (Figure 6A).
6A. Don't install the light bulbs if you want to install
the lower steel cap in Figure 7B (Figure 6B).
7. Assemble the opal frosted glass to the adapter
plate assembly by twisting in a clockwise direction.
Do not over-tighten (Figure 7A)
7A. Assemble the lower steel cap to the adapter plate
assembly by twisting in a clockwise direction.
(Figure 7B).
SCREWS (3)
LIGHT
SOCKET
LIGHT BULBS (2)
Figure 6A
OPAL
FROSTED
GLASS
Figure 7A
11
MOTOR ASSEMBLY
2-PIN CONNECTOR
SOCKET PLATE 2-PIN
CONNECTOR
SOCKET PLATE
ASSEMBLY
Figure 4
ADAPTER PLATE
ASSEMBLY
SOCKET PLATE
ASSEMBLY
Figure 5
LIGHT
SOCKET
Figure 6B
LOWER
STEEL
CAP ASSEMBLY
Figure 7B