Koenic KDW 60121 A2 BI Manual De Instrucciones página 24

Size - A5
English
Warning
• Only use salt specifically designed for
use in dishwashers! All other types of
salt not specifically designed for use
in a dishwasher, especially table salt,
will damage the dishwasher. In case of
damages caused by the use of unsuitable
salt the manufacturer does not give any
warranty nor is liable for any caused
damages.
• If salt has been spilled a soak or a rapid
program should be run to remove the
excess salt.
• Only fill with salt right before starting
one of the complete washing programs.
This will prevent any grains of salt or
salty water, which may have been spilled,
remaining on the bottom of the machine
for any period of time, which may cause
corrosion.
• The salt container must only be refilled
when the salt warning light in the control
panel comes on.
24
IM_KDW 60121 A2 BI_190411_V11_HR.indb 24
Adjusting salt consumption
Activate the setup mode: Close the
Fig.
3
door within 60 seconds after power
ON, press the
5 seconds, the machine will enter the
setting mode which is indicated by the
alternatingly blinking indicator lights of
and .
Adjust the level of salt
consumption: Press the
to select the proper setting according
to your local environment. Follow the
table below to find the correct setting.
Water Hardness level
°dH mmol/l
1)
0-5 0-0.94
6-11 1.0-2.0
12-17 2.1-3.0
18-22 3.1-4.0
23-34 4.1-6.0
35-55 6.1-9.8
The product will exit the setup mode
automatically 5 seconds after the last
setting/operation of the switch.
Note:
German measurement for the degree of
1)
water hardness
Millimol, international unit for water hardness
2)
Factory setting
*)
Contact your local water supplier for
information on the hardness of your water
supply.
button and hold it for
button
Setting
2)
H1
H2
H3*
H4
H5
H6
11/4/2019 10:08
Size -