Assembly; Fitting The Loop Handle; Assembling The Angle Gear; Assembling The Cutting Equipment - Husqvarna 525ECS Manual De Instrucciones

Fitting the loop handle

• Position the loophandle on the shaft. Note that the
handle must be mounted below the arrow on the shaft.
• Fit the bolt, securing plate and wing nut as shown in
the diagram.
• Tighten the wing nut.

Assembling the angle gear

Insert the driveshaft into the clutch drum, then attach the
gearbox to the shaft tube, aligning the positioning holes.
Fasten the screw (A) then fasten the clamp bolt (B) firmly
(6-8 Nm).
A
1157435-49 Rev. 3 2016-11-09
B

ASSEMBLY

Assembling the cutting
equipment
!
!

Assembling the blade

Fit the blade as follows:
C
D
1 Fit the drive disc (A) on the outgoing shaft. Make sure
that the edge that fits in the hole of the blade is facing
outward.
2 Block the blade rotation by inserting the locking pin (E)
in the hole behind the blade guard engaging it in the
corresponding hole in the drive disc.
3 Fit the blade (B) on the drive disc.
4 Fit the support flange (C). The support flange must be
fitted with its outer edge hard up against the blade.
5 Fit the locking nut (D). CAUTION! The locking nut has
a left-hand thread. Tighten the locking nut to a torque
of 15-20 Nm.
6 Remove the locking pin.
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
WARNING! Under no circumstances may
the edge cutter blade be used without the
blade guard fitted.
A
B
E
–
English 11