Bosch PMF 220 CE Manual Del Usuario página 17

OBJ_BUCH-2650-002.book Page 17 Monday, November 30, 2015 8:42 AM
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2011/65/EU, until
19 April 2016: 2004/108/EC, from 20 April 2016 on:
2014/30/EU, 2006/42/EC including their amendments and
complies with the following standards:
EN 60745-1, EN 60745-2-4.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 08.10.2015
Selecting the Application Tool/Accessory
The following table shows examples for application tools. Further application tools can be found in the extensive Bosch acces-
sories program.
Accessory
BIM segment saw
blade
Base plate for sand-
ing, series Delta
93 mm
Profile sander
BIM plunge cut saw
blade, wood and
metal
Bosch Power Tools
Assembly
Changing the Tool
 Before any work on the machine itself, pull the mains
plug.
 Wear protective gloves when changing application
tools/accessories. Contact with the application tool/
accessory can lead to injuries.
Please observe the application tools/accessories intended
for your tool.
Accessory
Material Application
Wooden materials, Separating and plunge cuts; also for sawing close to edges,
Plastic, in corners and hard to reach areas;
Non-ferrous metals example: shortening already installed bottom rails or door
hinges, plunge cuts for adjusting floor panels
Depends on sanding sheet Sanding surfaces close to edges, in corners or hard to reach
areas;
depending on the sanding sheet for, e.g., sanding wood,
paint, varnish, stone
Fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnishes, polishing felt for pre-
polishing
Wood, Convenient, efficient sanding of profiles up to a diameter of
Pipes/Profile, 55 mm;
Paint, Red sanding sheets for sanding wood, pipes/profiles, var-
Varnishes, nishes, fillers and metal
Filler,
Metal
Softwood, Smaller separating and plunge cuts;
Soft plastics, example: cutting an opening for sockets, flush cutting a
Plasterboard, copper pipe, plunge cuts in plasterboard
Thin-walled aluminium
Filigree adjustment work in wood;
and non-ferrous metal
example: sawing openings for locks and fittings
profiles,
Thin sheet metals,
Non-hardened nails and
screws
English | 17
PMF 220 CE
1 609 92A 1G1 | (30.11.15)