OVE LEA 60 Manual Del Usuario página 13

1. Place the support bar's anchor (I) back on it's wall mark, and mark the position of it's holes.
2. Drill a hole on the center marks with a ø8mm (5/16in) drill bit.
3. Insert the wall anchors (II) using a rubber mallet. Fix the center fitting on the support bar's anchor (I) using
the screws (JJ).
4-7. Install again the support bar (H) onto the fixed glass panel (C) and support bar anchor (I). Strongly tighten
the bolts using Allen key.
1
I
3
JJ
I
II
5
SUPPORT BAR INSTALLATION
I
6
13
2
Φ 8mm
5/16in
4
H
7