Intended Use And Installation Location - BAT Base Lite Manual Para Uso Y Mantenimiento

Use and maintenance manual
4

Intended use and installation location

The product is designed to protect against solar radiation and possibly to limit reverberation in the space below it.
Users of the product must be adults.
Improper use of the product shall absolve the Manufacturer of any liability from damage or injuries which might
result.
Failure to respect the indicated conditions of use shall cause any and all warranties provided by the
manufacturer to be forfeit.
The product, once installed, is intended only to perform raising or lowering of the fabric to reach the maximum
open and closed positions, as well as the intermediate ones if required.
The product must only be used for the purposes outlined above (even if packaged with impermeable or PVC
sheets).
· Any use other than those indicated above is forbidden, as different conditions of use could create
risks to the user and other persons nearby.
· The product MUST NOT be used to support/hold objects or for people to rest on.
· Close the product completely in the event bad weather or snow.
· The operation of the product with snow on the fabric or in freezing temperatures could damage it.
· For resistance to snow and water, see the pooling water resistance classes in Chap.Cap.5.1
"Technical features", pag.22.
·The formation of condensation on the fabric should not be considered a defect; it is a natural
phenomenon.
· Motorised versions must not be installed in potentially explosive (ATEX) atmospheres.
· In the event that the product is installed in a windy area with frequent power cuts, it is advisable to
install a back-up power supply.
The minimum installation height of the product should comply with applicable legislation; if fitted, the opening/
closing switch must be installed in a protected position, at a minimum, legal height from the ground and in an area
which is not dangerous to access.
Fig. 4 OPENING: Fabric stretched
to its maximum extension.
See the instructions given in the remote control manual (supplied).
· Use a lockable (key) switch if the structure is to be installed in sensitive locations such as schools,
colleges, hospitals, rest homes etc.
· If the product is fitted with a remote control, this must be kept out of the reach of children.
The remote control may also be used outdoors, as long as the system has an IP rating of IP55 or higher.
The space made available during installation must take into account the space required for movement and allow
the product to open fully.
· No ladders or other fixed objects must be installed or positioned near the product, such that the
spaces it needed are reduced.
05/09/2019 rev.04
All manuals and user guides at all-guides.com
Fig. 5 STOP: Stop of the move-
ment.
Base Lite
Fig. 6 CLOSURE: Fabric wrapped
around roller tube.
21