Introduction; Products; Handling And Transport - Ferroli AQUA1 PLUS 160 HT Manual De Instalación Y Mantenimiento

Installation and maintenance manual
1

INTRODUCTION

This installation and maintenance manual is to be
considered an integral part of the present heat
pump (hereafter referred to as equipment).
The manual must be kept for future reference until
the heat pump itself has been dismantled. This
manual is intended for both the specialised installer
(installers – maintenance technicians) as well as
the end user. The installation modes to be
complied with in order to achieve a correct and
safe operation of the equipment as well as
methods of use and maintenance are described in
this manual.
In case of the sale of the equipment or the
change of owner, the manual must accompany
the equipment to its new destination.
Before installing and/or using the equipment, read
this instruction manual carefully and, in particular,
chapter 0 relating to safety.
The manual must be kept together with the
equipment and, in any case, it must always be at
the disposal of the qualified personnel in charge of
installation and maintenance.
The following symbols are used inside the manual
in order to rapidly find the most important
information
:
Information on safety
Procedures to follow
Information/ Suggestions
1.1

Products

Dear Customer,
Thank you for having purchased this product.
Our company has always paid a great deal of
attention to environmental problems, therefore, it
has used technologies and materials with a low
environmental impact to manufacture its products
in conformity with RAEE – ROHS (2002/95/CE and
2003/108/CE) community standards.
2

HANDLING AND TRANSPORT

The equipment is supplied in a pallet.
Use a fork-lift truck or a pallet truck in order to
unload the equipment: it is opportune for these to
have a load capacity of at least 250 Kg.
In order to make it easier to loosen the fixing
screws the packaged equipment may be put in a
horizontal position on its back side.
The unpacking operations must be carried out
carefully so as not to damage the equipment
enclosure if this is carried out with knives or cutters
to open the cardboard packaging.
After having removed the packaging, make sure
that the unit is intact. If in doubt, do not use the
equipment and seek
technical staff.
In conformity with
regulations, make sure that all the accessories
supplied have been removed before discarding
the packaging.
WARNING! Packaging items (staples,
cardboard boxed, etc.) must not be
left within the reach of children as they
are dangerous.
2.1
Réception
En plus des unités à l'intérieur des paquets sont des
accessoires et contenaient la documentation
technique pour l'utilisation et l'installation. Vérifiez
que les composants suivants :
• Filter
• Installation et maintenance
• Manuel de l'utilisateur
help from authorised
environmental protection
pag. 2 / 23