Installation and maintenance manual
4.3
Device mounting and connection
The device must be installed on a stable, flat floor
surface that is not subject to vibration.
/50
4.4
Water supply connections
Connect the cold water inlet and the outlet pipes
to the appropriate connection points (Fig.5).
The table below shows the characteristics of the
connection points.
MOD.
Inlet cooling water
Recirculation
Outlet heating water
Condensate drain
Probe cockpit (only on models were
provided)
Fig. 5 – Water supply connections
160 / 200 /
UM
260
G 1
"
G 3/4
"
G 1
"
G 1/2
"
The following illustration (Fig. 8) shows an example
of a water supply connection.
Check valve
Fig. 6 – Example of the water supply system
pag. 11 / 23