AERMEC VMF-E2 Manual De Instrucciones E Instalación página 8

CONTENTS
Important information
Control panel functions
Use
Visualisations for the user
Installation information
IMPORTANT INFORMATION
WARNING: VMF-E2/E2Z are
designed for indoor use.
WARNING: the fan coil is con-
nected to power supply and
water circuit. Operations per-
formed by persons without the
required technical skills can lead
to personal injury to the operator
or damage to the unit and sur-
rounding objects.
WARNING: components sensi-
tive to static electricity may be
destroyed by discharge notably
lower than those at the human
perception threshold. These dis-
charges form when you touch a
component or electric contact of
a unit, without first discharging
accumulated static electricity
from your body. The damage
caused to the unit by an overvolt-
age is not immediately evident - it
only appears after a certain peri-
od of operation.
STATIC ELECTRICITY ACCUMULATION
Any person not connected in a con-
ductive manner with the electronic
potential of his surrounding envi-
ronment can accumulate electro-
static charges.
8
AVMFE2 1606 - 6795750_01
STANDARD PROTECTION
AGAINST ELECTROSTATIC
CHARGES
Earthing quality
When working with units sensi-
tive to electrostatic electricity,
ensure that people, workplaces
and unit casings are correctly
earthed. This will prevent the for-
mation of electrostatic charges.
Avoid direct contact
Only touch the element exposed
to electrostatic risk when abso-
lutely essential (e.g. for mainte-
nance).
Touch the element without com-
ing into contact with either the
contact pins or the wire guides. If
you follow this rule, the energy of
the electrostatic charges cannot
reach or damage the sensitive parts.
Before taking measurements on the
unit, it is necessary to discharge
all electrostatic charges from your
body: to do this, just touch an
earthed metal object. Only use
earthed measuring instruments.
POWER THE FAN COIL ONLY WITH
230V, SINGLE-PHASE VOLTAGE
Any other type of power supply could
permanently damage the fan coil.
ADJUST TEMPERATURE ADEQUATELY
The room temperature should be
adjusted in order to provide maxi-
mum comfort to the people in the
room, especially if they are elderly,
children or sick people; avoid dif-
ferences over 7°C between the out-
door temperature and the tempera-
ture inside the room in summer.
In summer, a temperature that is too
low causes higher electrical con-
sumption.
MALFUNCTIONING
In the event of a malfunction, cut
off power supply to the unit, then
restore the power and start the
unit again. If the problem occurs
again, call the local After-Sales
Service immediately.
DO NOT TUG THE ELECTRIC CABLE
It is very dangerous to pull,
tread on or crush the electric
power cable, or fix it with nails or
drawing pins.
A damaged power cable can
cause short circuits and injure
people.
8
9
10
11
12