DeWalt DWE4100 Manual De Instrucciones página 13

from your local dealer or authorized service center. Grinding and
cutting with wheels other than Type 27 and 29 require different
accessory guards not included with tool. A Type 1 guard is provided
for use with the Type 1 wheel. Mounting instructions for accessory
guards are shown below and are also included in the accessory
package.
MOUNTING AND REMOVING (TYPE 27)
ONE-TOUCH™ GUARD (FIG. 4, 5)
NOTE: If your grinder is supplied with a
keyless ONE TOUCH™ guard, ensure the
screw, lever and spring are fitted correctly
before mounting the guard.
1. Press the guard release lever (K).
2. While holding the guard release lever open,
align the lugs (L) on the guard with the
slots on the gear case (M).
3. Keeping the guard release lever open, push the guard down until
the guard lugs engage and rotate them in the groove on the gear
case hub. Release the guard release lever.
4. With the spindle facing the operator, rotate
the guard clockwise into the desired
working position. The guard body should
be positioned between the spindle and
the operator to provide maximum operator
protection.
5. For easy adjustment, the guard can be
rotated in the clockwise direction. NOTE:
The guard release lever should snap into
one of the alignment holes (N) on the
guard collar. This insures that the guard is secure. The guard can
be repositioned the opposite direction by depressing the guard
release lever.
6. To remove the guard, follow steps 1–3 of these instructions in
reverse.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose; 1/4" (6.35 mm) thick
wheels are designed for surface grinding while 1/8" (3.17 mm) wheels
are designed for edge grinding. Cutting can also be performed by
using a Type 1 wheel and a Type 1 guard.
OPERATION
FIG. 4
WARNING: To reduce the risk of injury, turn unit off and
N
disconnect it from power source before installing and removing
L
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
M
Guards and Flanges
It is important to choose the correct guards and flanges to use with
K
the grinder accessories. See page 9–10 and this page for the correct
accessories.
NOTE: Edge grinding and cutting can be performed with Type 27
wheels designed and specified for this purpose.
WARNING: Accessories must be rated for at least the speed
FIG. 5
recom mended on the tool warning label. Wheels and other
accessories running over rated accessory speed may burst and
cause injury. Every unthreaded accessory must have a 7/8" arbor
hole. If it does not, it may have been designed for a circular saw and
should not be used. Use only the accessories shown on pages 9–10.
Accessory ratings must be above listed minimum wheel speed as
shown on tool nameplate.
Switches
CAUTION: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come to
a complete stop be fore laying the tool down.
11