Din Front/Rear-Mount; Removing The Unit - Pioneer AVH-X7800BT Manual De Instalación

Installation
1
2
3
1 Dashboard
2 Leave gap
3 LCD panel

DIN front/rear-mount

This unit can be properly installed using either front-mount or
rear-mount installation.
Use commercially available parts when installing.
DIN Front-mount
1 Decide the position of the side brackets.
When installing in a shallow space, change the position of side
brackets (small).
1
2
1 Side bracket (small)
2 Flush surface screw (5 mm × 6 mm)
2 Install the unit into the dashboard.
Insert the mounting sleeve into the dashboard. And then secure
the mounting sleeve by using a screwdriver to bend the metal
tabs (90°) into place.
1
182
53
2
3
4
1 Dashboard
2 Mounting sleeve
3 Side bracket
4 Screw (2 mm × 3 mm)
DIN Rear-mount
1 Determine the appropriate position where the
holes on the bracket and the side of the unit
match.
When installing in a shallow space, use the following screw
holes.
1
1
1 Use binding screws (4 mm × 3 mm) only.
2 Tighten two screws on each side.
Use any of binding screws (4 mm × 3 mm), binding screws (5
mm × 6 mm) or flush surface screws (5 mm × 6 mm), depend-
ing on the shape of screw holes in the bracket.
3
1 Screw
2 Dashboard or console
3 Factory radio mounting bracket
In some types of vehicles, discrepancy may occur between
the unit and the dashboard. If this happens, use the supplied
frame to fill the gap.

Removing the unit

Extend top and bottom of the trim ring outwards to remove the
trim ring. And then loosen the screws (2 mm × 3 mm) to remove
the mounting sleeve.

When reattaching the trim ring, push the trim ring onto the
unit until it clicks. (If the trim ring is attached upside down,
the trim ring will not fit properly.)
1
2
1 Mounting sleeve
2 Screw (2 mm × 3 mm)
3 Trim ring
1
2
3
7