Start Up Instructions - Garland MULE 1162 NRQG-V18 Manual De Instrucciones

English

6. START UP INSTRUCTIONS

6.1. UNPACKING AND LIST OF MATERIALS
This machine includes the following items that you will
find inside the box:
• Machine
• Milling cutter set
• Transportation wheel
• Spur
• Pulley cord
• Plant-protecting plates
• Handlebar
• Belt cover
• Gear level
• Instruction manual
• Pneumatic wheels
Carefully inspect the product to ensure that there are
no damaged elements. If you find any damaged or
missing parts, do not use the machine until the defect
has been repaired or all the missing pieces replaced.
Using the machine without all of its parts or with
defective parts can cause severe personal injury.
6.2. ASSEMBLY
6.2.1. HANDLEBAR ASSEMBLY
Place the serrated base on the lower handle (1), the
upper handle (2), the wing nut washer (3) and screw
without tightening the wing nut (4).
Adjust the handlebar to the position in which you are
comfortable to get the job done and tighten the wing
nut (4) to leave the handlebar firmly in place.
2
1
6.2.2. MOUNTING THE MUD GUARD
Place the machine in a vertical position leaning on the
engine front:
Install the outer mud guards fixing them with the
screws provided.
42/180
4
3