Ryobi EID11002RV Manual De Utilización página 5

GB
FR DE ES
SPECIAL RULES
Wear ear protectors with impact drills. Exposure to
Q
noise can cause hearing loss.
Use auxiliary handles supplied with the tool. Loss
Q
of control can cause personal injury.
Hold power tool by insulated gripping surfaces,
Q
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live" and
could give the operator an electric shock.
SPECIFICATIONS
EID11002RV
Voltage 230 V
Chuck capacity 13 mm (1/2")
Drilling capacity
in wood 50 mm
in steel 13 mm
in masonry 20 mm
Input 1100 W
No load speed 0-1,200 / 0-3,200 min
Blows per minute 0-19,000 / 0-51,000 min
Weight 3.38 kg
DESCRIPTION
1. Trigger Switch
2. Forward / Reverse Selector
3. Keyless Chuck
4. Variable Speed Selector
5. Lock-on Button
6. Drill Mode Shift Knob
7. Depth Gauge
8. Auxiliary Handle
9. Bit (Not included)
10. Air Vents
11. Livetool Indicator™
12. To Tighten Chuck
13. To Loosen Chuck
14. To Tighten Handle
15. To Loosen Handle
16. Bit Storge
17. Spindle Lock
18. Bubble Level
19. Gear Setting Switch
STANDARD ACCESSORIES
Auxiliary handle and Depth Gauge.
IT NL PT DK SE
50 Hz
-1
-1
FI NO RU PL CZ
English
OPERATION
APPLICATIONS
(Use only for the purposes listed below.)
Drilling wood, materials and resin boards.
Q
Drilling concrete (impact drilling only).
Q
Drilling metal: steel, brass, aluminum sheets, stainless
Q
steel & pipe.
SWITCH
See Figure 1 & 3.
This tool can be started and stopped by squeezing
Q
and releasing the trigger switch (1).
The speed can be adjusted in either gear by
Q
controlling the force applied to the trigger.
The maximum speed of the drill may be set at different
Q
speeds by adjusting the variable speed selector (4).
For continuous operation, press the lock-on button (5)
Q
while squeezing the trigger. Squeeze the trigger again
to release the lock.
CHANGING THE ROTATION DIRECTION
See Figure 2.
To change the direction of rotation, stop the tool and
Q
push the forward / reverse selector (2).
When the forward selector is pushed in, the bit rotates
Q
clockwise when viewed from the handle end of the tool.
When the reverse selector is pushed in, the bit rotates
Q
counterclockwise.
MOUNTING AND REMOVING THE BIT
See Figure 4.
Insert the drill bit (9) into the chuck as far as the plain
Q
part of its shank will go.
Tighten the chuck securely by rotating the chuck head
Q
in a clockwise direction (12).
The bit can be removed by rotating the chuck in a
Q
counterclockwise direction (13).
CHANGING BETWEEN DRILLING AND IMPACT
DRILLING MODE
See Figure 5.
The drilling mode shift knob (6) for changing between
the drilling mode and impact drilling mode is positioned
on the top of the tool.
DRILLING MODE: Shift the knob to the "
showing "
1
HU RO LV LT EE
" symbol for drilling.
HR SI SK GR TR
" and