ALPHA-TOOLS ASE 20,4 Manual De Instrucciones página 11

Taladro percutor electrónico de batería con ajuste de par
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
nevertheless, wash the affec-
ted area of skin immediately
with soap and water. If
tery acid gets in your eye, rinse
the eye with clear water for at
least 10 minutes and consult
a doctor immediately.
9. Protect the charger and its
cable from damage and sharp
edges. Damaged cables are to
be replaced immediately by an
electrician.
10. Examine your tool for any
signs of damage. Have repairs
carried out only by an electrici-
an.
11. Make sure that the contacts of
the Ni-Cd battery pack do not
touch other metallic objects,
e.g. nails and screws. Risk of
short-circuiting!
Putting into operation:
Loading the Ni-Cd battery pack
1. Check that your mains voltage
is the same as that quoted on
the rating plate. Insert the
charger in a socket-outlet.
2. Pull the battery pack out of the
handle (Figure 5) by depres-
sing the clips on the side.
3. nsert the battery pack in the
charger. The red light comes
as a sign that the battery pack
is being charged. The green
LED comes on to signal that
the charging is completed. It
takes 1 hour to charge an
empty battery. The temperature
bat-
of the battery may rise slightly
during the charging operation.
This is normal.
If the battery pack fails to become
charged, please check
whether there is voltage at the
socket-outlet
whether there is proper contact
at the charging contacts on the
charger.
If the battery still fails to become
charged, please return
the charger
the battery pack
to our Customer Service
Department.
Timely recharging of the Ni-Cd bat-
tery pack is recommended in the
interest of long battery life.
Recharging is always necessary
when you notice that the power of
the battery-powered drill/screwdri-
ver is decreasing.
Never allow the battery pack to
discharge completely. This will
result in damage to the Ni-Cd bat-
tery pack!
Adjusting the torque (Figure 1)
The Alpha-tools battery-powered
drill/screwdriver is equipped with a
17-step mechanical torque adjust-
ment facility. The torque for a spe-
cific size of screw is selected with
GB
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

12.443.08

Tabla de contenido