Worx WX812 Manual Del Usuario página 10

COMPONENT LIST
1. AUXILIARY HANDLE
2. SPINDLE LOCK BUTTON
3. ON/OFF SWITCH
4. BATTERY PACK RELEASE BUTTON *
5. BATTERY PACK *
6. FILTER
7. WHEEL GUARD FOR GRINDING
8. DISC
9. SPANNER
10. INNER FLANGE
11. OUTER FLANGE
12. SPINDLE
13. GUARD CLAMPING LEVER
*Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type WX812 WX812.X (A-designation of
machinery, representative of sander and
grinder)
10
Charger voltage
Rated voltage
No load speed
Disc bore
Disc size
Spindle thread
Wheel
Machine weight
**X=1-999, A-Z, M1-M9 there are only used for
different customers, there are no safe relevant
changes between these models
***Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
20V Cordless Brushless Angle Grinder
WX812 WX812.X **
100-240V~ 50/60Hz
20V Max***
8500r/min
22.2mm
125mm
M14
Grinding (Type 27)
1.6kg-2.2kg
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 60745:
surface Vibration emission value
grinding or
a = 4.808m/s
h, AG
abrasive
Uncertainty K = 1.5m/s²
cutting off
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING! To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate)
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
L : 84.4dB(A)
pA
L : 95.4dB(A)
wA
3dB(A)
2
EN