Esoteric C-02X Manual Del Usuario página 16

Balance and input level settings (continued)
Left and right balance setting
(Bal>***)
Adjust the balance between the left and right output channels.
You can set this to values between L 6.0 dB and R 6.0 dB in 0.5dB
increments. You can also set this so that just one channel is muted.
The default value is 0.0 dB (no balance adjustment).
Muting just one channel
Press the k button to select "Bal>R only" to output only the right
channel.
Likewise, press the j button to select "Bal>L only" to output only
the left channel.
o When the balance has been adjusted, the BALANCE indicator
lights to show this.
Adjusting the output level
(Level>***)
You can adjust the output level for the selected input.
You can set this to values between –18.0 dB and +18.0 dB in 0.5dB
increments.
The default value is 0.0 dB.
o If the total of the output level and volume settings exceed 0 dB,
the output level indication will blink.
Lower the output level or volume until it stops blinking.
Note about these settings and sound quality
The left-right balance and output level settings are related to the
volume. This unit's microcomputer analyzes these settings and
the volume level value comprehensively to conduct unified con-
trol of volume amplification.
For this reason, unlike ordinary amplifiers that pass audio signals
through multiple circuits, these settings will not degrade the
audio quality.
16
Phase inversion
(Invert>***)
This can be used to reverse the phase of the audio signal output.
For example, if the XLR output of a device that sends a signal to this
unit's input is 2 HOT, but the XLR input of the device that receives the
signal output from this device is 3 HOT, set this to ON.
By default, this is set to OFF.
OFF
No phase inversion
ON
Phase inversion enabled
o When the polarity has been inverted, the POLARITY indicator
lights to show this.