Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: To aid accurate and easy positioning of the punch,
pull the switch trigger intermittently to jog the punch down
to the workpiece. If the position is not satisfactory, open
the return lever to retract the punch for another attempt. If
the punch doesn't return to its starting position with return
lever open, pull the switch trigger to return the punch.
NOTE: If the punch doesn't return after punching
finishes, release the switch trigger to stop the motor
and pull the switch trigger again.
If the punch doesn't return even after performing above
procedures, perform the procedures for stopping the oper-
ation before the completion of punching mentioned below.
Stopping the operation before the
punching is finished
If you want to stop the operation before the punching is
finished, perform the procedures below:
1.
Turn the return lever counterclockwise until it hits the
spring pin and then immediately back to its starting position.
Doing this releases the internal pressure of the tool. If the punch
retracts from the workpiece under its own power, allow the punch
to fully return. After that, turn the return lever back to its starting
position. In this case, the following step is not necessary.
2.
Continue to pull the switch trigger until the punch
returns to its starting position.
Using slide stopper for maximum depth
Optional accessory
CAUTION:
Before attaching or removing the
slide stopper, ensure that the battery cartridge
is removed to prevent accidental operation and
personal injury.
Punching up to 40 mm (1-37/64") depth from the edge of the
workpiece can be done using the optional slide stopper.
1
► 1. Bolt and washer 2. Optional slide stopper
1.
Loosen the set bolt and nut to remove the die.
2.
Remove the bolt and washer fixing the slide stopper.
3.
Remove the slide stopper by pulling it to the upper
side of the C frame.
4.
Insert the optional slide stopper for maximum
depth from the bottom side of the C frame.
5.
Fix the optional slide stopper with the bolt and
washer removed in step 2.
6.
Install the die with the set bolt and nut removed in step 1.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
Keep the air hole at the end of the C frame clear of dirt
and obstructions. The air hole has to be open in order to
control the hydraulic pressure.
► 1. Air hole
Do not undo or remove the three screws as shown in
the figure. Doing so will cause oil to leak from the tool.
2
This tool is electro-hydraulic. When shipped from the
factory, it was filled with the oil. Do not attempt to add oil
as long as the tool performs well. When the oil-pressure
is not enough for proper operation, add oil in the follow-
ing procedures.
13 ENGLISH
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Regular maintenance
Addling oil
1
Publicidad
Tabla de contenido
