Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING
Appliance will not operate
• Plug is not fully inserted into the wall outlet
• Blown fuse or circuit breaker
• Ambient humidity is lower than the set humidity
• Bucket is full or is not in the proper position
Insuffi cient dehumidifying
• Air fi lter is dirty
• Blocked air fl ow
• Appliance size is too small for application
• Ambient humidity is lower than the set humidity
Noise
• Air fi lter is dirty
• Bucket is not in proper position
• Floor surface is not level
Odors
• Formation of mold or mildew on internal wet
surfaces
• Place an algaecide tablet in the water bucket
Water on fl oor
• Hose connection is loose
• Drain cover has been removed
Frost build up
• When ambient temperature is below 5°C (41°F)
frost may form
• Switch the appliance to fan only mode until the
frost melts

ERROR CODES

If the display panel shows any of the below error
codes, unplug the appliance, let it stand for 5-10
minutes and then plug it back in. If the error
persists, call for service.
AS - Humidity sensor error
ES - Temperature sensor error
P2 - Full bucket or bucket not in the correct position
DISPOSAL
This appliance may not be treated as regular
household waste, it should be taken to the
appropriate waste collection point for recycling of
electrical components. Check for local regulatory
compliance regarding approved and safe disposal
of this appliance.
8

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ddr030bjwdb-meDdr040bjwdb-meDdr050bjwdb-me

Tabla de contenido