Tools And Materials; Before You Begin - Kohler K-5525 Guía De Instalación Y Cuidado

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

IMPORTANT SAFETY INSTRUCTIONS (cont.)
• Unawareness of impending risk
• Fetal damage in pregnant women
• Physical inability to exit the steambath
• Unconsciousness
IMPORTANT! Recommended feedwater quality should be: Hardness - less than 60 ppm (3.5 gpg); Total
Alkalinity - greater than 150 ppm (8.8 gpg). Calcium scale buildup from hard water can prevent proper
operation of the steam generator and may cause premature failure. To ensure proper operation, the
feedwater supply should be tested prior to operating the steam generator. If feedwater quality is not
within the specified limit, contact a reputable water treatment company for treatment options.
IMPORTANT! Maximum inlet water pressure is not to exceed 70 psi (483 kPa).
NOTICE: Use this unit only for its intended use as specified in this manual. DO NOT use attachments
not recommended by Kohler Co.
NOTICE: Do not apply excessive heat to the steam generator connections when you solder connections.
Do not apply flux or acids directly to the steam generator, as damage to the seals, plastic components, and
trim finish may result. Do not apply petroleum-based lubricants to the steam generator components, as
damage may result.
SAVE THESE INSTRUCTIONS.

Tools and Materials

Propane Torch
Hacksaw or Tube Cutter

Before You Begin

NOTE: The instructions in this installation guide cover both single and dual steam generator installations.
IMPORTANT! Provide an access panel of adequate size to permit removal of the steam generator for
servicing.
Inspect the product for any shipping damage. Do not install the unit if it is damaged. Contact the
Kohler Co. Customer Care Center using the information on the back of this guide.
Follow all local plumbing and electrical codes. All electrical work should be done by a qualified
electrician.
Disconnect all power before making any electrical connections.
Kohler Co.
Solder
Sealant Tape
Plus:
• Drain/spill pan
• 1/2" copper tubing
• Assorted copper fittings
• Wire Cutters or Wire Strippers
• Conventional woodworking tools and materials
• 45 and 90 degree elbows
• Support Blocks (heat resistant)
3
Drill w/ 1-1/4" &
2-1/2" Hole Bit
1230487-2-C

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

K-5526K-5529K-5531K-5539K-5543K-5559

Tabla de contenido