Operation - STERWINS 160HR EPW.3 Instrucciones Legales Y De Seguridad

5. OPERATION

Assembly
– Check it for visual defects.
– Check that all parts of the machine have been securely fitted.
– Check if the water connector and the high-pressure pipes are tight.
Starting and stopping
Note: put the high pressure washer on a smooth ground. Stand in a secure and stable position.
Starting:
i.
ii.
stream of water.
iii.
Stopping:
iv.
v.
vi.
Attention!
Risk of machine damage!
Never operate the machine without water inlet as dry running may damage the pump. Use a
water filter if the inlet water is contaminated.
EN
WARNING!
All assembly operations must be performed with the appliance disconnected
from the mains power supply.
The assembly sequence is illustrated in the characteristics manual. Pls refer to
the content to do the assembly job.
WARNING!
Wear suitable clothing, ears and eyes protecting when working with the
equipment. Ensure that the equipment is functional before each use. Ensure
that the mains voltage value matches the label on the equipment. The appliance
should only be connected to a mains power supply equipped with an adequate
earth connection and a differential security breaker (30mA) to cut off the
electricity supply in the instance of a short circuit.
Check the safe condition of the machine:
Open the water inlet valve
Press the safety button on the spray gun, and press the trigger until there is a steady
To switch the machine on, set the On(1)/Off(0) switch to ON(1).
Release the trigger.
To switch the machine off, set the On(1)/Off(0) switch to OFF(0).)
Close the water inlet valve
144