LG DLE1501 Serie Manual Del Propietário página 43

Error Codes
Problem
Error code: tE1 through tE7
Display shows error code: PS
*Flow Sense™ indicator shows
four bars during the drying
cycle or the display shows
"d80" after drying
* This warning light is
not a dryer failure and is
not covered by the dryer
warranty. Contact a duct
cleaning service to set up
an appointment to have your
exhaust system cleaned and
inspected.
The Flow Sense™ indicator
remains active after clearing
the restriction in the venting.
The display shows
indicator light is on during the
drying cycle
Possible Cause
Temperature sensor failure.
Power cord is connected
incorrectly.
Exhaust system is too long
or has too many turns/
restrictions.
Partial blockage of the
ductwork due to lint buildup or
other foreign object.
The appliance has detected a
restriction in the external dryer
venting.
After clearing the restriction,
the Flow Sense™ system
requires multiple, consecutive
cycles to determine that
the performance value has
improved before the Flow
Sense™ indicator is reset.
The duct work is about 75%
- 95% blocked.("d75", "d80",
"d90" or "d95" error code is
displayed for 2 hours only)
House exhaust system
blocked.
Lint filter not cleaned properly.
TROUBLESHOOTING
Solutions
• Turn off the dryer and call for service.
• Check the connection of the power cord to
the terminal block.
• Install a shorter or straighter duct run. See
the Installation Instructions for details.
• Ductwork should be checked/cleaned
immediately. Dryer can be used in this
condition, but drying times will be longer
and energy consumption will increase.
• If exhaust restrictions are sensed by the
Flow Sense™ system, the indicator will
remain on for 2 hours after the end of the
cycle. Opening the door or pressing the
Power button will turn off the display.
• If the Flow Sense™ indicator remains
active for more than five cycles after
the restriction has been cleared, call for
service.
• Do not use the dryer until the exhaust
system has been cleaned and/or repaired.
Using the dryer with a severely restricted
exhaust is dangerous and could result in a
fire or other property damage.
Check the outside dryer vent while the
dryer is operating to make sure there is
strong airflow.
If the exhaust system is extremely long,
have it repaired or rerouted.
• Keep the area around the dryer clean and
free of clutter.
Check vent hood for damage or lint
clogging.
Make sure the area around the vent hood
is clear.
• Remove the lint from the filter before
every load. With the lint removed, hold
the filter up to a light to see if it is dirty or
clogged. If it looks dirty, follow the cleaning
instructions. With some loads that produce
high amounts of lint, it may be necessary to
clean the filter during the cycle.
43