Aqua LITEPOOL pH Manual De Instalacion Y Uso página 15

2 in 1 Probe holder installation(ref. j) :
- Put the o-ring (ref. 8) on the injection tube
- Insert the injection tube inside the PVC tube, ensuring that the injection is in the same direction
as the pool circulation (indicated by the arrow on the sticker)
- Put the big o-ring in its seat keeping it in its position, place the upper part of the probe holder (ref.
j) on the PVC tube
- Use the screws to join the 2 parts of the probe holder (if the PVC pipe is DN63 use the 2 spacer
(ref. 9))
Warning Do not fully tighten one nut before the other.
Short probe Installation (ref. i)
1) Remove the cap from the electrode (do not throw away the cap as it is required for
maintenance and winter storage) Whilst the electrode is out of the system fill the cap ¾ full with
water before capping the probe.
2) Put 2 o-rings (ref. 7) on the electrode body
3) let the electrode cable pass through the cut on the nut (ref. 11)
4) Proceed with electrode calibration, (see chapter 3.4)
5) Carefully insert the electrode in the probe holder, until the o-rings reach their seat between the
cap and the probe holder. Then screw the nut with care (ref. 11).
Long probe Installation (120 mm)
- A standard electrode (12x120 mm) can be used, in that case you must use all the
accessories inside the kit
- Put the nut (ref. 11) on the probe body and than, alternatively, one spacer (ref. 6)
and one o-ring (ref. 7), like shown in the picture on the side
- Insert with care the electrode in the probe holder, having care that all the
components reach their seats. Then screw the nut with care (ref. 11).
Warning Do not bend the electrode otherwise it will be damaged. Electrode inner
part is very fragile.
25/07/2008
Installation of 4 x 6 tube
(ref. 2) on d e f g elements
15