Super Sealed Surface Burners; Important - Fulgor Milano Sofia Manual De Uso Y Cuidado

The Burner Flames
Turn each burner on. Flames should be blue in color with no
trace of yellow. The burner fl ames should not fl utter or blow
away from the burner. The inner cone of the fl ame should be
between 1/2" and 3/4" long.
NOTE: • Foreign material in the gas line, especially in new
construction, may cause an orange fl ame during
initial operation. The orange color will disappear
with further use. Small yellow tips on the ends of the
fl ames are normal when using LP gas.
• If the fl ame is not even around the edge of the burner,
wait for the cooktop to cool and check to make sure
the burner is assembled properly

Super Sealed Surface Burners

IMPORTANT

Do not obstruct the fl ow of combustion and ventilation air
around the burner grate edges.
Burner cap and gas spreader
Always keep the burner cap and gas spreader in place when
using a surface burner. A clean burner cap and spreader will
help prevent poor ignition and uneven fl ames. Always clean
the parts after a spillover and routinely remove and clean
according to the "General Cleaning" section.
Burner base and injector
Gas must fl ow freely throughout the injector orifi ce to light
properly. Keep this area free of soil and do not allow spills,
food, cleaning agents or any other material to enter the injector
orifi ce opening.
Protect it during cleaning.
BURNER FLAME
Be sure when lighting the burner:
• Gas spreader is seated correctly and pin is properly aligned
with burner base slot.
• Cap is seated correctly and pin is properly aligned with gas
spreader slot.
5 - Gas Cooktop Operation
Burner ports
Check burner fl ames occasionally. A good fl ame is blue in
color, not yellow.
Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
To Clean gas burner:
IMPORTANT
Before cleaning, make sure all controls are off and the
cooktop is cool.
1. Remove the burner cap from the burner base and clean
according to cleaning section.
2. Remove the burner spreader.
Clean the gas tube opening and burner port according to
cleaning section.
3. Clean the burner base with a damp cloth (keep the gas
injector area free of cleaning agents and any other material
from entering the injector orifi ce).
4. Replace the burner spreader and cap, making sure the
alignment pins are properly aligned with the slots.
5. Turn on the burner.
If the burner does not light, check cap and spreader
alignment. If the burner still does not light, do not service the
gas burner yourself.
Contact a trained repair specialist.
EXPLODED VIEW OF BURNER
EN
9