Bestron DFT35W Manual Del Usuario página 16

operAtion - General
The appliance is intended only for domestic use,
not for professional use.
1. Front Grill
2. Fan Blade
3. Rear Grill Screw
4. Rear Grill
5. Motor Shaft
6. Motor housing
7. Oscillation button
8. Stop button
9. Speed buttons
10. Power cord and plug
11. Base
12. Grill Screw
operAtion - before use for the first time
Remove the fan from the packaging.
operAtion - Assembling the fan
1. Unscrew the white locking ring from the shaft.
2. Fit the rear of the fan housing (4) onto the motor-housing (7), making sure that the openings are
aligned precisely with the lugs on the motor housing and that the grip is at the top.
3. Slide the locking ring (3) onto the shaft, and screw it tight (clockwise).
4. Slide the fan blades (2) onto the shaft, making sure that the notches are aligned precisely with the two
keys on the shaft.
5. The rim has clamps. Carefully fit the rim around the rear half of the fan housing, making sure that
the housing falls into the upper clamp of the rim, so that you can connect the two halfs of the fan
housing with the nut and bolt (12). Use a crosshead screwdriver.
6. Close the other clamps.
operAtion - Ventilate
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see Figure 2). You can set the fan:
a. to blow horizontally (position a) or angled slightly downwards (position b). Tilt the ventilator housing
and motor housing to the required angle.
b. to oscillate from left to right (with a sweep of 90 °). This will ventilate much of the room. Press the
oscillation button on the motor housing fully in.
c. remain in the same position whilst the fan
is turning. This will ventilate one area. Pull
out the oscillation button until you hear it
click.
3. Put the plug into the wall socket.
4. Switch on the fan by pressing one of the three
speed buttons.
a. Position '1', the fan operates at low speed.
b. Position '2', the fan operates at normal
speed.
c. Position '3', the fan operates at high speed.
5. Stop the fan by pressing the stop button
(position '0').
2
8
5
6
a
b
16
user's instructions
1
4
3
7