Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting
Hours of operation:
Monday to Thursday 8:30 am - 6:00 pm Eastern Standard Time
Friday 8:30 am - 4:00 pm Eastern Standard Time
Note: Information in this manual is subject to change without notice.
Problem
No power
Cabinet temperature
is too high.
Condensation on
the cabinet, doors or
fl oor.
Wine cooler runs
continuously.
Danby Consumer Care: 1-800-263-2629
Possible Cause
•
A fuse in your home may be
blown or the circuit breaker
tripped.
•
Power surge.
•
Plug not fully inserted into
the wall outlet.
•
Temperature setting.
•
Door not shut properly or
opened excessively.
•
Recently added a large
quantity of warm bottles to
the cabinet.
•
High humidity conditions in
the home.
•
Door not shut properly or
opened excessively.
•
Temperature set too cold.
•
Door is not closed.
•
Door opened too long or too
often.
•
Close proximity to heat
source or direct sunlight.
What to do
•
Replace fuse or reset circuit breaker.
•
Unplug the wine cooler, wait a few
seconds and then plug it back in
•
Make sure the 3-prong plug is fully
inserted into the outlet.
•
Verify the temperature control setting.
Adjust if neccessary.
•
Ensure that the door is fully closed
and that the gasket is sealing against
the cabinets. Open the doors only as
needed and for short periods of time.
•
Limit the quantity of warm bottles
being introduced to the cabinet at the
same time. Attempt to stagger the
load introduction if possible.
•
The condensation will subside once
humidity conditions return to normal.
•
Ensure that the door is fully closed
and that the gasket is sealing. against
the cabinets. Open the door only as
needed and for short periods of time
•
Adjust temperature to warmer setting.
•
Close door securely.
•
Minimize door opening duration and
frequency.
•
Do not place unit close to heat
sources or direct sunlight.
9
Publicidad
Tabla de contenido
