Troubleshooting - Danby DWC93BLSDB Manual De Instructions

Ocultar thumbs Ver también para DWC93BLSDB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Troubleshooting

Occasionally, a problem may arise that is minor in nature, and a service call may not be necessary. Use this trou-
bleshooting guide for a possible solution. If the unit continues to operate improperly, call an authorized service depot or
Danby's Toll Free Number 1-800-263-2629 for assistance.
PROBLEM
1) No power.
2) Cabinet temperature too
high.
3) Condensation on the
cabinet and/or doors.
POSSIBLE CAUSE
• A fuse in your home may be
blown or a circuit breaker
tripped
• Power surge
• Plug is not fully insterted into
wall outlet.
• Temperature Setting.
• Door not shut properly or
opened excessively.
• Exhaust vent is obstructed.
• Recently added large quantity of
warm bottles to cabinet.
• High humidity conditions in the
home.
9
SOLUTION
• Replace fuse or reset circuit
breaker.
• Unplug the wine cooler, wait a
few seconds and plug back in.
• Make sure the 3-prong plug is
fully inserted into outlet.
• Verify the temperature control
setting; adjust if necessary.
• Ensure door is fully closed and
the gasket is sealing against the
cabinets. Open door only as
needed and for short periods of
time.
• Verify that nothing is blocking
front-mounted exhaust vent.
• Limit quantity of warm bottles
introducted at the same time.
Stagger the load introduction if
possible.
• Ensure door is fully closed and
gasket is sealing against the
cabinet. Open the door only as
needed and for short periods of
time.

Publicidad

Tabla de contenido
loading

Tabla de contenido