Clatronic BS 1230 Instrucciones De Servicio página 35

5....-05-BS 1230
Overview of the Components
1 Cable
2 On/off switch
3 Vacuum power regulator
4 Carrying handle
5 Cable-winding key
6 Dust bag filling display
7 Hose connection
8 Vacuum hose
9 Handle for opening the dust bag
compartment
10 Dust bag compartment
• Insert the connection head of the suction hose (8) into the hose connector (7)
until its locks in place (use the recess to guide you). In order to release the hose
again, please press the buttons once more on the connection head.
• Keep the buttons pressed down and then pull out the hose.
• Please insert the 2 parts of the suction tube (11) into one another (section with
the hook facing downwards) and then attach it to the handle section.
• Then assemble the floor nozzle (12) and/or the accessories.
1. Unwind the length of cable (1) you require.
2. Insert the mains plug into a correctly installed safety socket (230 V, 50 Hz) and
then switch the machine on using the on/off switch (2).
3. Set the vacuum power with the vacuum power regulator (3).
4. Vacuum at a steady speed. There is no need to exert pressure.
5. Attention: pay attention to the range that can be covered with the cable length.
Vacuum power regulator:
Low vacuum power:
Medium vacuum power:
High vacuum power:
Cable winding device:
Pull out the cable (1) up to the maximum length indicated with the yellow mark.
Never pull the cable out up to the red mark as the cable winding can be damaged.
Said damages are not covered by the warranty.
04.03.2003 11:29 Uhr
Start-up
11 Suction tube, 2-part
12 Floor nozzle
13 Accessory compartment
14 Hook on the suction tube
15 Parking assistance (not shown)
Accessories:
Upholstery nozzle
"2-in-1" nozzle (groove and brush nozzle)
Using the Appliance
For curtains and delicate fabrics
For long-pile velour carpets and textile flooring
For sturdy rugs and floors
Seite 35
GB
35