Clatronic BS 1230 Instrucciones De Servicio página 36

5....-05-BS 1230
Winding:
GB
Press the cable (5) winding button and guide the cable. Hold the cable to avoid wrap-
ping.
Accessory Compartment (13):
Pull open the lid of the accessory compartment to access the integrated accesso-
ries (upholstery nozzle, crevice nozzle/brush nozzle). Take out the nozzle you requi-
re:
Nozzle accessories:
Crevice nozzle/Brush nozzle: To vacuum corners and slits
Upholstery nozzle:
Floor nozzle:
Releasing the accessories: Pull these off while turning slightly.
Air Slide:
Open the air slide on the handle of the hose to regulate the air supply or to clear off
any particles sticking to the nozzle.
Dust bag replacement display (6):
Hold the hose up into air. If the dust bag change display lights up, the bag is full.
Please change it.
Changing the dust bag:
Remove the mains plug from the socket. Then open the lid of the dust bag com-
partment (10) by pressing the button (9). Remove the bag holder, press the button
with the spring together in order to release the bag and then pull the dust bag out
of holder. Press the button again and fix a new bag in place. Re-insert the bag hol-
der and then close the lid so that its locks in place.
Filter: Your appliance has two filters.
Motor protection filter (inlet filter):
The inlet filter is located in the dust bag compartment. The filter is located vertically
in the rear section of the dust housing. Remove the filter by pulling upwards. Clean
the engine protection filter after 10 dust bag changes. If necessary, the filter can
also be washed in warm water without any additives. Place it back into place only
once it is completely dry!
36
04.03.2003 11:29 Uhr
"2-in-1" nozzle: When this is folded together (as sto-
red in the compartment) it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull
the brush section in the direction of the arrow until it
locks in place.
To clean upholstery, curtains, etc.
To clean carpets or smooth surfaces.
Seite 36