LD Systems VIBZ 12 Manual De Usuario página 10

42
FOOT SW DFX MUTE
6.3 mm jack socket for connecting a foot switch (pedal) to remotely activate and disable the mute function of the internal effects device
(footswitch optional).
43
MAIN MIX OUTPUT
Balanced stereo line output with 3-pin XLR jack sockets to connect an active PA system. Output of the master signal of the mixer.
44
MAIN MIX
Balanced stereo line output with 6.3 mm jack sockets to connect an active PA system. Output of the master signal of the mixer.
45
2 TK OUT
Unbalanced stereo line output with RCA sockets for connecting an external recording device (e.g. laptop). Output of the master signal of the mixer.
46
MAIN MIX
Volume controller for the stereo line outputs MAIN MIX OUTPUT (N 43), MAIN MIX (N 44) and 2 TK OUT (N 45). Push the Fader button
upwards to increase the volume, and downwards to decrease it. Before you turn on the power of the connected PA system, set the volume
controller to minimum.
47
OUTPUT LEVEL
2 x 12-segment LED level display for visualising the volume level of the stereo sum channel. To avoid distortion, reduce the volume level of
the output channel as soon as the red CLIP LED lights up.
48
GR OUT
Unbalanced stereo line output with 6.3 mm jack sockets to connect an active PA system etc... Output of the group signal of the mixer.
49
GR1-2
Volume controller for the stereo line output GR OUT (N 48). Push the Fader button upwards to increase the volume, and downwards to
decrease it. Before you turn on the power of the connected PA system, set the volume controller to minimum.
50
AUX SEND 1
Unbalanced mono line output with 6.3 mm jack socket to activate an external effects device (POST Fader), or an active stage monitor (PRE
Fader).
51
SENDS AUX1
Volume controller for the sum of the signals from the input channels 1 to 11/12 routed via the AUX1 level controller (N 10).
52
AUX SEND 2
Unbalanced mono line output with 6.3 mm jack sockets to activate an external effects device (POST Fader). When using the AUX SEND 2
jack socket, the internal effects device is automatically bypassed, and is therefore not usable.
53
+48V ON / OFF
+48 V phantom power supply for operating high-quality condenser microphones without own power supply. Press down to select the ON
position to turn on the phantom power for the XLR microphone inputs (red LED light N 54 is on), and return to the original OFF position
to turn it off (red LED light is off). Turn on the phantom power only after connecting a microphone, or off after disconnecting, and set the
volume controller of the channels 1 to 7/8 to minimum before this step.
54
+48V LED
LED display for the +48 V phantom power.
55
POWER CONNECTOR WITH FUSE HOLDER
IEC power socket with built-in fuse holder. An appropriate power cord is included in the delivery. IMPORTANT INFORMATION: Always replace
the fuse only with a fuse of the same type with the same rating (printed on the device). If the fuse blows repeatedly, please contact an
authorised service centre.
10