LD Systems VIBZ 12 Manual De Usuario página 9

28
PHONES / CTRL
Volume controller for the stereo line output CTRL (N 27) and the headphone output PHONES (N 26). When using headphones, make sure
that the volume stays at a pleasant level, in order to avoid hearing damage caused by loud noise.
29
CTRL/PHONES MAIN / GR1-2
To listen to the MAIN MIX sum channel, bring the switch to the up position MAIN; to listen to the group signal, press down on the switch
(down position GR1-2).
30
2 TK IN
Unbalanced stereo line input with RCA sockets for connecting an external audio source with line level (e.g. MP3 player).
31
2 TK IN LEVEL
Volume controller for the stereo line input 2 TK IN (N 30). Turning the dial to the right increases the volume and turning it to the left decreases it.
32
2 TK IN TO MAIN / TO CTRL
This switch allows you to route the incoming signal of the stereo line input 2TK IN either to the stereo line output MAIN MIX OUT (not
pressed down = TO MAIN), or to the stereo line output CTRL OUT and headphone output PHONES (pressed down = TO CTRL).
33
DFX PRESETS
100 different effects presets are available to you. Use the rotary encoder to select one of the presets as desired (digits in the display N 34
will flash), and then confirm the entry by briefly pressing on the encoder (the digits on the display stop flashing).
34
DFX DISPLAY
The four digit LED display shows the number of the selected effect preset.
35
DFX PEAK LED
Once the red Peak LED lights up, the input of the internal effects device is operating at the distortion limit. Adjust the Effect Send controller
DFX SENDS AUX2 (N 36) so that the peak LED only lights up briefly when signal peaks occur.
36
DFX SENDS AUX2
Volume controller for the sum of the signals from the input channels 1 to 11/12 routed via the DFX/AUX2 level controller (N 12).
37
DFX TO MAIN
Volume controller for adding the effects signal of the internal effects device to the sum channel MAIN MIX. Push the Fader button upwards to
increase the volume of the effect and downwards to decrease it.
38
DFX MUTE
In order to mute the internal effects device, briefly press the DFX Mute button once, and again to turn mute off. If Mute is active, the DFX
Peak LED lights up continuously.
39
DFX PFL
Press down on the PFL switch (Pre Fader Listen) to be able to listen to the effects signal regardless of the channel volume controller DFX TO
MAIN (N 37) whilst using headphones connected to the headphone jack PHONES (N 26). The PFL LED lights up. If the PFL switch is brought
to its original position (not down), the PFL LED will go out.
40
DFX TO AUX1
Volume controller for adding the effects signal of the internal effects device to AUX 1 output.
41
EFFECTS LIST
List of effects programs for the internal effects device.
9