Failure Display And Inspection - Orima ORF-71 IN Libro De Instrucciones

Fan noise coming from
the induction hob.
Pans do not become
hot and appears in the
display.
The induction hob or a
cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).

Failure Display and Inspection

If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem Possible causes
F3-F8 Temperature sensor failure
F9-FE
Temperature sensor of the IGBT
failure.
E1/E2 Abnormal supply voltage
E3/E4 Abnormal temperature
E5/E6 Bad induction hob heat
radiation
The above are the judgment and inspection of common failures.
Please do not disassemble the unit by yourself to avoid any dangers and damages
to the induction hob.
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue to
run even after you've turned the
induction hob off.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot detect
the pan because it is too small
for the cooking zone or not
properly centred on it.
Technical fault.
This is normal and needs no action.
Do not switch the power to the
induction hob off at the wall while the
fan is running.
Use cookware suitable for induction
cooking. See section 'Choosing the
right cookware'.
Centre the pan and make sure that its
base matches the size of the cooking
zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
Please inspect the pot.
Please restart after the
induction hob cools down.
EN-20