Ingersoll Rand 170 Instrucciones página 2

Note the position of the reversing lever before
•
operating the tool so as to be aware of the direction
of rotation when operating the throttle.
Use only impact sockets and accessories. Do not
•
use hand (chrome) sockets or accessories.
The use of other than genuine Ingersoll- - Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll- - Rand Authorized
Servicenter.
WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
Lubrication
Ingersoll- - Rand No. 10
(Oil)
Always use an air line lubricator with these tools.
We recommend the following Filter- - Regulator- - Lubricator
(FRL) Unit:
Inside USA use FRL unit # C28- - 04- - FKG0- - 28
Outside USA use FRL unit # C28- - C4- - FKG0
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 10 Oil
into the air inlet.
Periodically, inject several drops of Ingersoll- - Rand
No. 10 Oil between the Ratchet Housing (39) and Ratchet
Yoke (37) to lubricate the Drive Bushing (36).
Drive
Speed
Model Model
Inches
170 3/8"
1770 1/2"
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested in accordance with ISO8662- - 1
Using the Tool (Continued)
WARNING SYMBOL IDENTIFICATION
PLACING THE TOOL IN SERVICE
Ingersoll- - Rand No. 28
For the Gearing
and
For the Ratchet Housing
Ingersoll- - Rand No. 66
(Grease)
SPECIFICATIONS
Recommended
Free
Torque
Range
rpm ft- - lbs (Nm)
160 10- - 60 (14- - 81)
160 10- - 60 (14- - 81)
Whenever the Ratchet Head is installed or
•
repositioned, the Throttle Lever must be positioned
so that reaction torque will not tend to retain the
throttle in the "ON" position.
Ratchet Wrenches are not torque wrenches.
•
Connections requiring specific torque must be
checked with a torque meter after fitting with an
impact wrench.
CAUTION
NOTICE
WARNING
Read this manual before
operating tool.
Main Line(s) Inner Ø
to be 3X Size of
Air Tool's Inlet Ø
To Air
System
To Air
Tool
Emergency
Shut--Off
Valve
Lubricator Regulator
Drain Regularly
HSound Level
dB (A)
Pressure Power
97.8 110.8
97.8 110.8
2
WARNING
Always wear hearing
protection when operating
this tool.
Installation
Branch Line(s) Inner Ø
to be 2X Size of
Air Tool's Inlet Ø
R
L
F
Filter
FRL
Compressor
(Dwg. TPD905- -2)
Inlet
♦Vibrations
Connec-
Level
tion
Thread
2
m/s
Type
3.9 1/4" NPT
3.9 1/4" NPT
Minimum
Inside Ø
Air Hose
Inches
(mm)
1/4 (6.35)
1/4 (6.35)