Cleaning And Maintenance - Teka DHT 85 Serie Manual De Instrucciones

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in the
diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure that
a steady air flow has been established before
fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel all
the grease from the outlet duct. This prevents
the return of grease, smoke and smells.
ON/OFF
ON/OFF
Decrease selected
funtion
Filter saturation
indicator
Program the working time
• Turn the hood on and select the required
extraction speed
• Select the programming time by pressing
Timer.
• Each press of the button increases the
programming time by 10 minutes, up to a
maximum of 80 minutes.
• To reset the programme, wait for over a
second and press the Timer button again.
• The speed and extraction time are displayed
with the LED indicator.
• The intensive speeds 6, 7 and 8 cannot
be programmed. These must be selected
manually and have a maximum duration of
approximately 10 minutes.
Receiver
Emitter
Light
Increase selected
funtion
Timer
LED
Filter saturation indicator
• Clean the filters when all lights of the
LED indicator begin to flash followed
by an acoustic signal.
• Press "Filter Saturation" to reset this
feature
Cleaning the metal filters
During cleaning and maintenance
work, make sure the safety instructions
are complied with.

Cleaning and maintenance

•If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does
not produce fibres.
•Do not use vapour cleaners
Cleaning the hood body
•To remove the filters from their fittings,
press lightly on the locks and then pull them
off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent
until the fat dissolves and then rinsing them
under the tap or using special anti-grease
products. They can also be washed in a
dishwasher. In this case, it is advisable to
stack them vertically to avoid food residues
to stick to them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although
this will not affect its fat retention capacity.
•Once clean, leave them to dry off and then
fit them onto the kitchen hood.
Lights
For changing the light bulbs please contact the
manufacturer's nearest Technical Service.