Cleaning And Maintenance; Changing Light Bulbs - Teka DH2 Serie Manual De Instrucciones

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in
the diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking
(between 3 to 5 minutes) in order to expel
all the grease from the outlet duct. This
prevents the return of grease, smoke and
smells.
Display
Timer
Decrease selected funtion
Increase selected funtion
Light
Program the working time
1)Switch on the cooker hood and choose
the required aspiration speed.
2)Push 'Timer'.
3)Select the required programming time
from 1 to 99 minutes by using the buttons
'+' and '-'.
4)The display will alternately show the clock
and the remaining programming time.
The maximum speed 'H' can only be
selected manually and will be changed
automatically to the second speed level
after approximately 10 minutes.
Cleaning the metal filters
During cleaning and maintenance
work, make sure the safety instructions
are complied with.

Cleaning and maintenance

•If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does
not produce fibres.
•Do not use vapour cleaners
Cleaning the hood body
•To remove the filters from their fittings,
press lightly on the locks and then pull them
off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent
until the fat dissolves and then rinsing them
under the tap or using special anti-grease
products. They can also be washed in a
dishwasher. In this case, it is advisable to
stack them vertically to avoid food residues
to stick to them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although
this will not affect its fat retention capacity.
•Once clean, leave them to dry off and then
fit them onto the kitchen hood.

Changing light bulbs

Proceed as follows:
•Unscrew the lamp cover.
•Change the broken / burnt out lamp.
•Screw the lamp cover back in.