Publicidad
OBJ_BUCH-0000000268-001.book Page 19 Thursday, December 22, 2016 11:31 AM
Symbol, character
Explanation
Low speed
High speed
Reduce torque
Increase torque
(**)
may contain numbers and letters
***
Partially in delivery scope
Character
Unit of measurement,
international
V
U
f
Hz
-1
n
/min, min
, rpm, r/min
0
-1
n
/min, min
S
M...
Nm
Ø
mm
L
dB
pA
L
dB
wA
L
dB
pCpeak
K...
2
m/s
2
m/s
h,D
2
m/s
h
m, s, kg, A, mm, V,
W, Hz, N, °C, dB,
2
min, m/s
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in electric shock,
fire and/or serious injury.
Save all warnings and instructions for future reference.
Do not use this power tool before you have thor-
oughly read and completely understood this
Instruction Manual and the enclosed "General
Safety Instructions" (document number
3 41 30 054 06 1). The documents mentioned should be
kept for later use and enclosed with the power tool,
should it be passed on or sold.
Please also observe the relevant national industrial safety
regulations.
Intended use of the power tool:
Hand-held cordless drill/driver for screwing in and
unscrewing screws and nuts, and for drilling and screw-
driving in metal, wood, plastic, ceramics in weather-pro-
tected environments without water supply using the
application tools and accessories recommended by FEIN.
Unit of measure-
Explanation
ment, national
V
DC voltage
Hz
Frequency
rpm
No-load speed (with fully charged battery)
/min
Impact rate
Nm
Torque (hard/soft screwdriving application)
mm
Diameter of a round part
dB
Sound pressure level
dB
Sound power level
dB
Peak sound pressure level
Uncertainty
2
m/s
Vibrational emission value according to EN 60745
(vector sum of three directions)
2
m/s
Mean vibrational value for drilling in metal
2
m/s
Arithmetic mean value of the vibration total values
m, s, kg, A, mm, V,
Basic and derived units of measurement from the
W, Hz, N, °C, dB,
international system of units SI.
2
min, m/s
Special safety instructions.
Use auxiliary handle(s), if supplied with the tool. Loss of
control can cause personal injury.
Hold the power tool by the insulated gripping surfaces
when performing operations where the application tool
could contact hidden wires. Contact with a "live" wire
will also make exposed metal parts of the power tool
"live" and shock the operator.
Beware of any concealed electric cables, gas or water
conduits. Check the working area before commencing
work, e. g. with a metal detector.
Wear personal protective equipment. Depending on appli-
cation, use face shield, safety goggles or safety glasses.
Where appropriate, wear dust mask, hearing protectors,
gloves and workshop apron capable of stopping small
abrasive or workpiece fragments. The eye protection
must be capable of stopping flying debris generated by
various operations. The dust mask or respirator must be
capable of filtrating particles generated by your opera-
tion. Prolonged exposure to high intensity noise may
cause hearing loss.
en
19
Publicidad
