Tabla de contenido
Publicidad
•
Note: the on/off switch controls the adjustable comb lock switch to ensure consistent
grooming results. When the trimmer is turned on the comb lock switch is enabled.
When the trimmer is turned off the comb lock switch is disabled. This is when the comb
length is able to be adjusted.
TO THIN AND TAPER THE BEARD/MOUSTACHE
1. Fit the adjustable comb.
2. Use the zoom wheel to set the comb to the desired length setting.
3. The setting will appear on the length position indicator. If you are trimming for the first
time start with the maximum trimming length setting.
4. Turn the unit on.
5. Place the flat top of the trimmer comb against the skin.
6. Slowly slide through the hair. Repeat from different directions as necessary.
7. If hair builds up in the trimmer comb during the trimming process, switch the unit off,
pull the comb and brush the hair off.
Note: Use the beard trimmer without the adjustable comb for trimming hair close to the
skin. This will trim hair to 1mm, holding the blades perpendicular to the skin will trim hair to
0.4mm.
TRIMMING THE NAPE OF YOUR NECK
Note: you will need a hand mirror for this operation if performing it alone.
1. Remove the adjustable comb.
2. Use your fingers to lift the hair at the base of your head up off the neck. Your index
finger should be covering the roots of the hairs you are lifting to prevent accidental
removal by the beard trimmer.
3. Using your other hand, hold the trimmer to the base of your neck with the cutting unit
facing up and move the trimmer up the length of the neck until it touches your finger
covering the hair roots at the base of your head.
4. Be sure to move the unit slowly when performing this operation and to keep the roots
at the base of your head out of the way of the trimmer.
TO DEFINE THE BEARD/MOUSTACHE LINE
1. Hold the trimmer with the trimmer blade facing you.
2. Start with the edge of beard/moustache line and gently lower the trimmer blade onto
your skin.
3. Use motions towards the edge of the beard/moustache line to trim to desired locations
in facial area and away from beard in neck area.
BLADE RELEASE
1. Ensure the trimmer is switched off.
2. Remove the adjustable comb.
3. Remove the blades by pushing your thumb upwards under the blades and move the
blade set away from the trimmer body.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5
Publicidad
Tabla de contenido
