UFESA DH5010 Manual De Instrucciones página 35

The display will show „P1".
It will be activated for a period of 8 minutes every 38 minutes between 2-12°C.
It will also be activated for a period of 5 minutes every 60 minutes between 12-16°C.
MANUAL DRAINING
When water tank is full, the water-full indicator is on.
The unit will stop working and buzzer will sound 10 times till water is pour off.
Take out water tank, pour away water.
Replace the water tank, dehumidifier restarts working.
Please install the water tank as the Fig 2.
Note: Do not remove the float from the water tank.
The water full sensor will no longer be able to detect the water level correctly without the float and water
may leak from the water tank.
CONTINUOUS DRAINAGE
Connect a plastic hose (with an inner diameter of 9 mm) to the continuous drainage port via the small
hole.
Water can be drained continuously.
Please check if the pipe is stably connected with the drainage mouth, or water will flow out. Fig.3
Note: Water pipe cannot be too long (usually 0.6m), the height cannot surpass the height of drainage
mouth, or there will be water leakage.
AFTER HAVE FINISHED USING THE APPLIANCE
Stop the appliance by releasing the pressure on the on/off button.
Unplug the appliance from the mains.
Remove the water from the water tank.
For storing, stand the unit upright and avoid exposure to the direct sunlight.
CLEANING
Turn off the unit and disconnect the power plug before starting any cleaning task.
Cleaning the body:
Wipe the dehumidifier with a dry and soft cloth.
To remove heavy dirt, wipe it with a cloth wrung tightly.
Never use a wet cloth for cleaning the control panel.
DO NOT IMMERSE IN WATER OR ANY OTHER LIQUID.
35