Start Up Instructions - Garland XTRIM 140 DW Manual De Instrucciones

5. INSTRUCTIONS FOR
COMMISSIONING
5.1. MATERIAL'S LIST
This machine includes the following items that you
will find inside the box:
• Machine.
• Protector.
• Guard screw (x3).
• Head
• Disk
• Front handle
• Manual.
Carefully remove all items from the box and make
sure all items listed are present.
Inspect the product carefully to ensure that there are
no damaged items. If you find any damaged part or
something missing, do not use the machine until the
defect has been repaired or you have all the parts
that make up the machine. Using the machine with
defective parts or without all its elements can cause
severe personal injury.
5.2. ASSEMBLY
5.2.1. ASSEMBLY THE PROTECTOR AND HEAD
Position the protector (1) as shown in the figure,
matching the notches. Then insert the 3 screws (5)
and tighten.
Fit the bushing (2), tighten the cutting head (3).
5.2.2. FRONT HANDLE ASSEMBLY
Place lever (18) on handle (6) and align with pressure
plate (19). Tighten the screws (20).
31/124
English