Configuration; Setup Port Attributes - Longshine LCS-SW1420S Manual Del Usuario

Configuration

Port attributes can be setup in this page.

Setup Port Attributes

1. Click the "Name" column of the port. Enter a name for identification, like
'Richard'; and press Enter
2. Leave the "Admin" column 'Enable' value to make the port to be in operation
or 'Disable' to pause it
3. Select Duplex mode---10Half/10Full; 100Half/100Full; 'Auto' for
auto-negotiation and 1000Full auto-detection
4. Select 'Enable' to take "Flow Control" effect
5. Click Apply button to apply settings
Note
Also accomplished by simply mouse right-click the port on the 'Panel Display'
then select 'Configuration', the configuration screen pops up
E-32