In-Band Connections (Web Browser/ Telnet); Starting A Telnet Session - Longshine LCS-SW1420S Manual Del Usuario

5.2 In-Band Connections (Web Browser / Telnet)
To manage the switch through in-band access, you should configure the
management station with an IP address and subnet mask compatible with
your clustering switch. Both standalone switch and the cluster can be
managed using either a standard Web Browser or a Telnet session from
any computer attached to the network. The SNMP management feature
also permits the switch to be managed from any SNMP network
management station running a network management program.
Factory Default value:
IP
Subnet Mask
Default Gateway
To manage the Standalone switch
---Access the switch with its IP address "10.0.0.1" (factory default value)
To manage any of the Clustering switch
---Access the switch with the IP address of Master device in the stack. Then
select the switch you want to manage in the home page

Starting a Telnet Session

To access the switch through a Telnet session
1. Sure of the switch is configured with an IP address and the switch is
reachable from a PC
2. Start the Telnet program on a PC and connect to the switch
Note
The management functions of Telnet program are exactly the same with
web-based management interface but in text mode. For further operation, please
refer to 'Starting a Web Browser Session'.
10.0.0.1
255.0.0.0
10.0.0.254
E-22