MIRKA PROS 525NV Instrucciones De Manejo página 51

WARNING
Always wear required personal safety protection in accordance with manufacturer's instructions and local/national
standards while using this tool .
• Do not use a power tool if you are tired or under the influence of drugs, alcohol or medication .
• Read the Materials Safety Data Sheet (MSDS) for the working surface .
• Use the tool with dust extraction . A suitable dust extraction unit will reduce hazardous dust .
• Do not overreach . Keep proper footing and balance at all times .
• Do not wear loose clothing or jewellery . Keep your hair, clothing and gloves away from moving parts .
Loose clothes, jewellery or long hair can be caught in moving parts .
• If any physical hand/wrist discomfort is experienced, stop working and seek medical attention .
Hand, wrist and arm injury may result from repetitive work, motion and overexposure to vibrations .
• Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids, gases or dust .
• The tool is not electrically insulated . Check work area for live electricity, gas pipes, etc . before operation .
CAUTION
• Prevent unintentional starting .
• Remove pad wrench before connecting the tool to the air supply .
• Keep work area clean and well lit .
• Always ensure that the work piece to be sanded is firmly fixed .
• Before changing abrasive always disconnect the air supply .
Additional safety warnings
• Read all instructions before using this tool . All operators must be fully trained in usage and safety of this tool .
• All maintenance must be carried out by trained personnel . For service, contact Mirka authorized service centre!
• Always wear required safety equipment (see warnings) .
• The operator must be in a secure position and have a firm grip and footing on a solid floor .
• Always ensure that the work piece to be sanded is firmly fixed .
• Check tool, backing pad, hose and fittings regularly for wear .
• Always take care to ensure your safety at work; never carry, store or leave the tool unattended with the air supply
connected .
• Vacuum unit dust collection bag should be cleaned or replaced daily . Dust can be highly combustible .
Cleaning or replacing of bag also assures optimum performance .
• Do not exceed maximum recommended air pressure of 6 .2 bar (90 psi) .
• Take care to avoid entanglement of the moving parts of the tool with clothing, ties, hair, cleaning rags, etc .
• Keep hands clear of the spinning pad during use .
• If the tool appears to malfunction, remove from use immediately and arrange for service and repair .
• Before changing abrasive always disconnect the air supply . Take care to properly attach and centre the abrasive
on the backing pad .
Mirka® PROS • 150 mm (6") • 125 mm (5")
en
51