Bosch GLI 12V-300 Professional Manual Original página 15

OBJ_BUCH-2962-001.book Page 15 Tuesday, October 11, 2016 11:20 AM
English | 15
The lithium-ion battery can be charged at any time without reducing its service life. In-
terrupting the charging procedure does not damage the battery.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the cordless worklight is switched off
by means of a protective circuit.
 Do not continue to press the On/Off switch after the cordless worklight has
been automatically switched off. The battery can be damaged.
To remove the battery 5, press the unlocking button 4 and pull the battery out of the
cordless worklight. Do not exert any force.
Observe the notes for disposal.
Operation
Initial Operation
Inserting the battery
Insert the charged battery 5 into the battery port until it can be felt to engage and is
seated flush.
Switching On and Off
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Working Advice
Utility Hook (see figure A)
You can use the utility hook 3 to attach the cordless worklight to an object.
Aligning the Cordless Worklight (see figure B)
The cordless worklight can be used standing up, hanging or lying down. Its hexagonal
shape enables the light to be aligned according to its use.
Maintenance and Service
Maintenance and Cleaning
When the battery is no longer operative, please refer to an authorised after-sales ser-
vice agent for Bosch power tools.
Bosch Power Tools 1 609 92A 39F | (11.10.16)