Install The Plumbing - Kohler ABRAZO K-1800 Manual De Instalación

Apply silicone
sealant to
Drain
both sides.
Gasket
Drain
Bath
Body
Drain Pipe

3. Install the Plumbing

CAUTION: Risk of property damage. Make sure a watertight seal exists on all bath drain
connections.
Make the Drain Connections
NOTE: The drain cover and gaskets are included in a small box located within the carton.
Choose the thin drain gasket for PVC drain pipes or the thick gasket for brass pipes.
Apply silicone sealant to the inside and outside surfaces of the drain gasket to act as a lubricant.
Use a rubber mallet and short section of 1-1/2" PVC tubing to install the drain gasket onto the drain
pipe.
Line up the tabs on the drain cover with the slots in the drain body, and insert the drain cover
assembly into the flange.
Press the drain cover several times to make sure the drain opens and closes properly.
Apply Sealant - Optional
If desired, apply a thin, continuous bead of clear or color-matched silicone sealant to the seam
between the bath and the finished floor.
Install the Bath Filler
Install the faucet valve and trim according to the faucet manufacturer's instructions.
Close the bath drain. Fill the bath to the overflow, and check for leaks.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, visit www.kohler.com/clean. To order Care &
Cleaning information, call 1-800-456-4537.
Kohler Co.
Drain
Cover
Tab
Slot
Drain
Body
Bath
5
Check for leaks.
Apply sealant.
(optional)
1207308-2-A