Installation Instructions; Technical Data; Symbol Description; Flow Diagram - Hansgrohe Showerpipe Croma 220 Reno 27224000 Modo De Empleo/Instrucciones De Montaje

6
Safety Notes
6 Gloves should be worn during installation to prevent crushing and cutting
injuries.
6 The arm of the shower head is intended only to hold the shower head. Do not
load it down with other objects!
6 Children as well as adults with physical, mental and/or sensoric impairments
must not use this shower system without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from using this shower system.
6 Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
6 The product may not be used as a holding handle. A separate handle must be
installed.
6 The shower system may only be used for bathing, hygienic and body cleansing
purposes.

Installation Instructions

• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The fitting must be installed, flushed and tested after the valid norms!
• Where the contractor mounts the product, he should ensure that the entire area
of the wall to which the mounting plate is to be fitted, is flat (no projecting joints
or tiles sticking out), that the structure of the wall is suitable for the installation
of the product and has no weak points. The enclosed screws and dowels are
only suitable for concrete. For another wall constructions the manufacturer's
indications of the dowel manufacturer have to be taken into account.
• If required, the bottom part of the pipe between the fixture and the shower head
can be shortened with a fine-toothed saw.
• The mesh washer must be insert to protect the overhead shower against incoming
dirt by pipework. Incoming dirt leads to defects or/and can damage parts of the
shower; such caused faults voids all liability and guarantee claims.
• The shower may only be connected following (downstream from) a shut-off valve
of the sanitary fitting.
• The installation dimensions stated in this installation instructions are ideal for
people of approximately 1800 mm in body height. The dimensions can be
altered if required. In this case you will have to attend to the minimum height of
2236 mm from shower tray floor, and alter all the required measurements as
necessary.

Technical Data

Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Thermal disinfection:
anti-pollution function
The product is exclusively designed for drinking water!
4
English
max. 0,6 MPa
0,1 – 0,4 MPa
max. 60°C
max. 70°C / 4 min
Assembly see page 31

Symbol description

Do not use silicone containing acetic acid!
Maintenance (see page 36)
The non return valves must be checked regularly according to DIN
EN 1717 in accordance with national or regional regulations (at least
once a year).
Spare parts (see page 37)
Special accessories
Grease (90920000) order as an extra
Dimensions (see page 33)

Flow diagram

(see page 33)

Hand shower

overhead shower

Hand shower + overhead shower
Operation (see page 36)
Cleaning (see page 36) and enclosed brochure