Samsung NX58 665 Serie Manual De Instalación página 29

Estufa de gas
Ocultar thumbs Ver también para NX58 665 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To adjust flame low setting
Identify which burner is exhibiting too high or too low of simmer rate via manifold
panel graphics.
Simmer Set Screw
WARNING
1.
Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve
set screw will cause gas to leak.
2.
After adjusting the valve set screw, inspect the assembly for gas leaks.
Install_NX58M6650WS_DG68-00992A-05_EN+MES+CFR.indb 29
1.
Rotate a knob to "LO" position and
remove the knob from the valve shaft
while the flame is lit.
2.
Carefully push the screw driver into
the C chanel of the valve, until it hits
the simmer set screw. Make sure the
screwdriver flathead is seated into the
set screw groove.
3.
Rotate valve set screw clockwise to
decrease "LO" setting flame output, or
rotate set screw counter clockwise to
increase "LO" setting flame output.
Memo
English 29
2018-12-19
6:12:47

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Nx58 663 serie

Tabla de contenido