Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BLUETOOTH®
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press
to enter Bluetooth mode.
2
Turn the volume knob to select [CALL HISTORY], [PHONE BOOK], or
[NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
4
Press and hold one of the number buttons (1 to 6).
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER DIAL] in step
and store a blank number.
Make a call from memory
1
Press
to enter Bluetooth mode.
2
Press one of the number buttons (1 to 6).
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
Other settings
1
Press the volume knob to enter [FUNCTION].
2
Turn the volume knob to select an item (see the following table),
then press the knob.
3
2
Repeat step
until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press and hold
to exit.
To return to the previous setting item, press
20
BT MODE
PHONE SELECT
AUDIO SELECT
DEVICE DELETE
PIN CODE EDIT
(0000)
2
RECONNECT
AUTO PAIRING
INITIALIZE
.
Selects the phone or audio device to connect or disconnect.
"
*
" appears in front of the device name when connected.
• You can only connect a maximum of two Bluetooth phones and one
Bluetooth audio device at any time.
1 Turn the volume knob to select a device to delete, then press the
knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
Changes the PIN code (up to 6 digits).
1 Turn the volume knob to select a number.
2 Press S / T to move the entry position.
1
2
Repeat steps
and
until you finish entering the PIN code.
3 Press the volume knob to confirm.
ON: The unit automatically reconnect when the last connected
Bluetooth device is within range. ; OFF: Cancels.
ON: The unit automatically pair supported Bluetooth device (iPhone/
iPod touch/ Android device) when it is connected through USB input
terminal. Depending on the operating system of the connected device,
this function may not work. ; OFF: Cancels.
YES: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; NO: Cancels.
Default: XX
Publicidad
Tabla de contenido
