Information About Noise Level And Vibrations; Certificate Of Conformity - Narex EBU 15-16 C Instrucciones De Uso

English
Warranty
Our equipment is under warranty for at least 12 months with regard to
material or production faults in accordance with national legisla-
tion. In the EU countries, the warranty period for exclusively private
use is 24 months (an invoice or delivery note is required as proof
of purchase).
Damage resulting from, in particular, normal wear and tear, over-
loading, improper handling, or caused by the user or other dam-
age caused by not following the operating instructions, or any
fault acknowledged at the time of purchase, is not covered by the
warranty.
Complaints will only be acknowledged if the equipment has not been
dismantled before being sent back to the suppliers or to an au-
thorised NAREX customer support workshop. Store the operating
instructions, safety notes, spare parts list and proof of purchase in
a safe place. In addition, the manufacturer's current warranty con-
ditions apply.
Information about noise level and
vibrations
The values have been measured in conformity with EN 60745.
EBU 15-16 C
Acoustic pressure level L = 89 dB (A).
pA
Acoustic power level L = 100 dB (A).
wA
In accuracy of measurements K = 3 dB (A).
ATTENTION! Noise is generated during work!
Use ear protection!
The weighted value of vibrations affecting hands and arms
a = 10.5 m.s .
-2
h,AG
In accuracy of measurements K = 1.5 m.s
EBU 15-16 CA
Acoustic pressure level L = 89 dB (A).
pA
Acoustic power level L = 100 dB (A).
wA
In accuracy of measurements K = 3 dB (A).
ATTENTION! Noise is generated during work!
Use ear protection!
The weighted value of vibrations affecting hands and arms
a = 5.4 m.s .
-2
h,AG
In accuracy of measurements K = 1.5 m.s
The emission values specified (vibration, noise) were measured in
accordance with the test conditions stipulated in EN 60745 and are
intended for machine comparisons. They are also used for making
preliminary estimates regarding vibration and noise loads during
operation.
The emission values specified refer to the main applications for
which the power tool is used. If the electric power tool is used for
other applications, with other tools or is not maintained sufficient-
ly prior to operation, however, the vibration and noise load may be
higher when the tool is used.
Take into account any machine idling times and downtimes to
estimate these values more accurately for a specified time period.
This may significantly reduce the load during the machine operat-
ing period.
18
.
-2
.
-2

Certificate of Conformity

We declare that the device meets requirements of the following
standards and directives.
Safety:
EN 60745-1; EN 60745-2-3
Directive 2006/42/EC
Electromagnetic compatibility:
EN 55014-1; EN 55014-2; EN 61000-3-2;EN 61000-3-3
Directive 2004/108/EC
2013
Narex s.r.o.
Chelčického 1932
470 01 Česká Lípa
Changes are reserved
Antonín Pomeisl
CEO of the company
01. 06. 2013