QEP 22750Q Instrucciones De Funcionamiento página 8

FIGurE 4
3. Remove blade shaft nut and outer flange.
4 . Carefully place the blade onto the shaft and
push it against the inner flange.
5 . Be sure the side of the blade with the
directional arrow is facing towards you .
6. Place the outer flange and the blade shaft
nut onto blade .
7. Hold blade and firmly tighten the blade shaft
nut with the included wrench, but do not
over tighten (see FIGURE 5) .
FIGurE 5
8. Replace baffle and right cutting table.
CONTINUOUS RIM BLADES WITH THIS SAW.
DO NOT USE SEGMENTED, "TURBO" BLADES,
WOOD SAWING BLADES, BLADES WITH
OPENINGS, OR ANY OTHER CUTTING DEVICES
WITH THIS TILE SAW. USING THESE BLADES
COULD RESULT IN SERIOUS PERSONAL
INJURY AND DAMAGE TO THE SAW.
inStaLLinG tHe BLade GUard
1 . Place blade guard support into the slot on
the top-rear side of the table . (Figure 6)
2 . Be sure the support is lined up with the
blade .
USE ONLY
FIGurE 6
3 . Slip the back end of the blade guard down
over the blade guard support (see FIGURE 7) .
4 . Replace the knob into the blade guard, while
being careful to hold bolt on the right side in
place, then tighten (see FIGURE 7) .
FIGurE 7
5 . It is suggested that the front of the blade
guard be pointed slightly down to minimize
the front splash during cutting .
inStaLLinG tHe riP GUide
1 . Slip the back of the rip guide on the back
edge of the table (see FIGURE 8)
2 . Place front of rip guide down on the font
edge of the saw .
3 . Position for the size of the cut to be
performed and tighten front knob . (see
FIGURE 9)
FIGurE 8
– 6 –